FENCES CLEANING
The Big Move
Fence Cleaning & Wood Restoration in Central, TX
Stop letting a gray, moldy fence drag down your property value. We use specialized fence pressure washing techniques to strip away years of sun damage and organic growth, bringing back the natural color of your wood or the bright shine of your vinyl without splintering the surface.
- Gray Wood Surface Stripping
- Vinyl Oxidation Removal
- Deep Algae & Mold Kill
- Prep for Staining or Sealing
Perimeter & Gate Check
We start by checking the structural integrity of fence. We look for loose boards or rusted hardware that might react to the water. We also make sure your gates are cleared of debris so our pressure washing equipment can get to every corner.
Uniform Surface Restoration
Wand marks are the sign of a bad job. Our crew uses steady, overlapping passes to ensure a completely even finish. We strip away the "dead" gray top layer of wood to reveal the fresh, tan-colored timber underneath.
Pressure-Tuned Cleaning
Not all fences are built the same. We calibrate our machines based on the material, higher pressure for concrete-set vinyl and a lower, controlled fan for delicate cedar or pine. This ensures we lift the dirt without "furring" the wood fibers.
Final Rinse & Debris Flush
Washing a fence can kick up a lot of mud at the base. We finish by flushing the bottom of the pickets and rinsing any overspray off your lawn or flower beds, leaving your fence line crisp and the surrounding area spotless. etails.
Organic Growth Neutralization
Fences are magnets for green algae and mildew, especially in shaded areas. We use a professional-strength wash to kill the roots of the mold, ensuring your fence doesn't just look clean, but stays sanitized against the elements.
Frequently asked questions
Common Fence Care Questions From the Neighborhood
It’s the closest thing to a time machine for wood. By stripping away the UV-damaged gray layer, we reveal the original color of the wood. Once it dries, it’ll be perfectly prepped if you’re planning on applying a fresh coat of stain or sealer.
Definitely. Vinyl requires a specific touch; too much pressure in the wrong spot can cause a crack. We use a high-flow, lower-PSI setting that "slides" the oxidation and dirt off the plastic without stressing the material.
We’re very careful with your lawn. We pre-soak the grass and use biodegradable cleaners that are diluted during the rinse process. Your grass stays green, but the mold on your fence dies, that’s the goal.
In the Copperas Cove, TX, sun, a fence usually feels dry to the touch in a few hours. However, if you’re planning to stain it, we recommend waiting 24 to 48 hours to ensure the moisture deep inside the wood fibers has fully evaporated.